Problems with Brother printers and the usb:// uri

[Michael Sweet]

Alastair Mailer wrote:
> See this post at Gentoo Linux forums:
> 
> http://forums.gentoo.org/viewtopic-p-4225198.html
> 
> After following the instructions at Brother's linux support page:
> 
> http://solutions.brother.com/linux/en_us/index.html
> 
> I managed to get my Brother DCP-130C working fine, printing several documents. However, I came back to print today and CUPS throws an error stating that my printer is disconnected and that it'll retry in 30 seconds. I tried deleting the printer and using the CUPS wizard to set it up again, but although CUPS could detect my printer was connected and ran through the wizard fine, upon trying to print a test page I was still in the same situation.
> 
> I eventually came upon the above post in the Gentoo forums, and the problem was fixed by changing the device URI from "usb://Brother/DCP-130C" to "file:/dev/usb/lp0". This is obviously not ideal, as I had to override the restriction on file uri's in the config file. Have I done something wrong or is this a bug?

It is likely a Gentoo Linux bug - probably the HPLIP USB drivers are
conflicting with the kernel USB driver.

-- 
______________________________________________________________________
Michael Sweet, Easy Software Products           mike at easysw dot com
Internet Printing and Publishing Software        http://www.easysw.com