Epson Stylus CX6600

[Russ Fineman]

Brian Hechinger wrote:

> Roger Leigh wrote:
>> Russ Fineman <russbucket at centurytel.net> writes:
>> > I noticed the driver you are using is for a CX6400, have you tryed the
>> > CX66 driver available at the following Epson site?
>> >
>> > http://www.epkowa.co.jp/english/linux_e/dl_spc.html
>>
>> That's rather non-free software, but it should work.
>>
>> > I'm considering a CX6600 so it would be nice to see you get yours
>> > working.
>>
>> If you prefer a free solution, you could try a newer release of
>> Gimp-Print (now Gutenprint):
>>
>>  
http://people.debian.org/~rleigh/gutenprint/sid/5.0.0-beta3/gutenprint-5.0.0-beta3.tar.bz2
>>
>> This is a snapshot of the forthcoming 5.0.0-beta3 release.  It has
>> proper support for the CX6600.
> 
> 
> I just built the 5.0 beta yesterday, but in my poking and proding i've
> found that i can write to the printer (print a nozzle check page with
> escputil) but i cannot read from the printer, so i'm going to first start
> off by dumping OpenBSD and putting a current version of NetBSD on that
> laptop, we'll see if that helps at all.
> 
> i'll keep you updated as to the status of all of this.
> 
> -brian

Thanks for the update. Since I use CUPS for printing now can I also use the
gimp printer or do I need to uninstall CUPS? I'm relatively new to Linux I
hope you don't mind the question.

Thanks again.
-- 
Russ