[cups.general] USB printer not showing up
Matt Hull
mhull1 at uic.edu
Sun Sep 18 11:45:07 PDT 2005
i dont think you need to make the device your self. and did you check
dmesg ? might be in /dev/usb/lp0 ?
matt
On Sun, 18 Sep 2005, Wim wrote:
> My USB printer is not showing up in the device section, when I want to install it with the web interface.
>
> Some output which might be helpful
> # lpinfo -v
> network socket
> network http
> network ipp
> network lpd
> direct scsi
> serial serial:/dev/ttyS0?baud=115200
> serial serial:/dev/ttyS1?baud=115200
> # lsmod
> Module Size Used by
> usblp 8096 0
> ..
> # dmesg | tail
> usbcore: registered new driver usblp
> drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
> usb 3-1: new full speed USB device using ohci_hcd and address 2
> drivers/usb/class/usblp.c: usblp0: USB Bidirectional printer dev 2 if 0 alt 0 proto 2 vid 0x04E8 pid 0x3236
>
> Cups was compiled manually from "cups-1.2svn-r4629-source.tar.bz2".
>
> I've restarted cups a few times, but that didn't help.
> Does anyone have any idea what could be missing and how I can solve it?
> Anything else I could check? I have a feeling this is going to be something very simple I overlooked, but I have no clue what :/
>
>
> Thanks in advance for any help or hints!
>
> _______________________________________________
> cups mailing list
> cups at easysw.com
> http://lists.easysw.com/mailman/listinfo/cups
>
More information about the cups
mailing list