[cups.general] Automatic printer tray selection?

[Minatra, Pat H.]

Not sure what you are using but on HP printers you set that up in the printer configuration on board the printer itself, you don't want CUPs to do it.

-------------------------
"Life is but a twinkle in the eye of eternity"
"The shortest distance between a problem and a solution is the distance between your knees and the floor"
"sorrow looks back - worry looks around - faith looks up"
Regards,
Pat H. Minatra - N5GJR
(325) 670-5804 voice
(325) 670-1570 fax
Hardin-Simmons University           Datatel Colleague Support:
www.hsutx.edu                       GL, CF, HR, PE, PR, AP
PO BOX 16040                        OneCard Support:
Abilene, TX  79698                  SysAdmin, DBAdmin
-------------------------           -------------------------
The mission of Hardin-Simmons University is to be a community dedicated to providing excellence in education enlightened by Christian faith and values.
-------------------------
PRIVILEGED AND CONFIDENTIAL NOTICE: The information contained in this e-mail may be confidential and/or privileged. This e-mail is intended to be reviewed initially by only the individual named above. If the reader of this e-mail is not the intended recipient or a representative of the intended recipient, you are hereby notified that any review, dissemination or copying of this e-mail, or the information contained herein, is prohibited. If you have received this e-mail in error, notify the above sender, send the message back and then delete it.
-------------------------
Thank you for your assistance. Hardin-Simmons University; 2200 Hickory/HSU Box 16040; Abilene, TX  79698; 325.670.1000
------------------------- 


-----Original Message-----
From: cups-bounces at easysw.com [mailto:cups-bounces at easysw.com] On Behalf Of Pete Tirrell
Sent: Monday, August 11, 2008 8:25 AM
To: cups at easysw.com
Subject: Re: [cups.general] Automatic printer tray selection?

> Does CUPS not support automatic tray selection for printers??  Under the printer setup, for Media Source, I can only seem to select a single tray source.
>
> How can I configure things so if the default tray is empty, it will go on to the next tray and pull paper from there??
>
> Thanks for any info!

bump?
_______________________________________________
cups mailing list
cups at easysw.com
http://lists.easysw.com/mailman/listinfo/cups