number-up margins not behaving as expected
Brian Muntz
bmunter at yahoo.com
Thu Mar 25 19:05:46 PDT 2010
Thanks Michael. Info below
Suse: 11.2
CUPS: 1.3.9
Driver: HP Laserjet 9040 MFP Foomatic/Postscript
> What OS/Linux distribution?
>
> What version of CUPS?
>
> What driver?
>
> On Mar 24, 2010, at 6:53 PM, Brian wrote:
>
> > All -
> >=20
> > I am printing a 6 page PDF 2-up in duplex. Command as follows:
> >=20
> > lp -d HP_9040 -o media=3D11x17 -o sides=3Dtwo-sided-long-edge -o =
> number-up=3D2 -o fitplot Binder1.pdf
> >=20
> > My issue is everything works great except that there is about a 1" =
> margin around everything. I have tried almost every option to scale it =
> larger, shrink margins, etc but I can not get rid of that 1" margin. I =
> have seen a couple other posts with this same question but never =
> answered (at least that I can find).
> >=20
> > Does anyone have insight on this issue or experienced this before with =
> 2-up printing? 1-up works fine. Just with 2 or more on same page it =
> puts this unmovable margin around it. Any help is much appreciated :)
> >=20
> > Thank you
> > Brian
> > _______________________________________________
> > cups mailing list
> > cups at easysw.com
> > http://lists.easysw.com/mailman/listinfo/cups
>
> ________________________________________________________________________
> Michael Sweet, Senior Printing System Engineer, PWG Chair
>
>
>
>
>
More information about the cups
mailing list