[cups.general] Zebra S4M 300dpi
Michael Sweet
msweet at apple.com
Wed May 16 14:46:28 PDT 2012
Bill,
>From a terminal/command window, enter the command below. Substitute the name of your print queue for "printer":
lpadmin -p printer -o DefaultResolution=300dpi
If you are unsure about the printer queue name, run:
lpstat -v
to list them.
On May 16, 2012, at 2:03 PM, Bill Ehnis wrote:
> I am new at this. Were do in enter this info.
>
>> Pick 300dpi as the default resolution (the normal default is 203dpi)
>>
>> lpadmin -p printer -o DefaultResolution=300dpi
>>
>> On May 16, 2012, at 12:51 PM, Bill Ehnis wrote:
>>
>>> I have a Zebra S4m 200dpi that works fine.
>>> I also have a New Zebra S4m 300dpi that prints 30% small. Not full size.
>>> Is there away to fix this?
>>> Thinks
>>>
>>> _______________________________________________
>>> cups mailing list
>>> cups at easysw.com
>>> http://lists.easysw.com/mailman/listinfo/cups
>>
>> ________________________________________________________________________
>> Michael Sweet, Senior Printing System Engineer, PWG Chair
>>
>
> _______________________________________________
> cups mailing list
> cups at easysw.com
> http://lists.easysw.com/mailman/listinfo/cups
________________________________________________________________________
Michael Sweet, Senior Printing System Engineer, PWG Chair
More information about the cups
mailing list