Zebra S4M 300dpi

[Bill Ehnis]

Thinks,
I found that the application,in this case FileMaker Pro. was forcing to printer to print as 203 dpi. When I changed the settings in FileMaker, the printer know prints at 300 dpi.

> Bill,
>
> >From a terminal/command window, enter the command below.  Substitute the name of your print queue for "printer":
>
> 	lpadmin -p printer -o DefaultResolution=300dpi
>
> If you are unsure about the printer queue name, run:
>
> 	lpstat -v
>
> to list them.
>
>
> On May 16, 2012, at 2:03 PM, Bill Ehnis wrote:
>
> > I am new at this. Were do in enter this info.
> >
> >> Pick 300dpi as the default resolution (the normal default is 203dpi)
> >>
> >> lpadmin -p printer -o DefaultResolution=300dpi
> >>
> >> On May 16, 2012, at 12:51 PM, Bill Ehnis wrote:
> >>
> >>> I have a Zebra S4m 200dpi that works fine.
> >>> I also have a New Zebra  S4m 300dpi that prints 30% small. Not full size.
> >>> Is there away to fix this?
> >>> Thinks
> >>>
> >>> _______________________________________________
> >>> cups mailing list
> >>> cups at easysw.com
> >>> http://lists.easysw.com/mailman/listinfo/cups
> >>
> >> ________________________________________________________________________
> >> Michael Sweet, Senior Printing System Engineer, PWG Chair
> >>
> >
> > _______________________________________________
> > cups mailing list
> > cups at easysw.com
> > http://lists.easysw.com/mailman/listinfo/cups
>
> ________________________________________________________________________
> Michael Sweet, Senior Printing System Engineer, PWG Chair
>